> Is anybody able to build tdebase without HAL > (WITH_HAL=OFF)? > > Anybody? > > > > I'm dead in the water unless I can build without HAL. > (Bug report 1132.) > > > > In file: tdm/backend/CMakeLists.txt > Look at section "include_directories" (line 14) > (notice the self-explanatory comment just above ...) > > Inside this section, add another line just after > ${DBUS_TQT_INCLUDE_DIRS} > ${DBUS_INCLUDE_DIRS} > > And try again ... Turns out this failure is more fundamental. After comparing builds with WITH_HAL=ON and WITH_HAL=OFF, I noticed the latter build never looked for dbus-tqt and always failed. I found success with the following temporary patch: ================================================= diff -urN tdebase/ConfigureChecks.cmake tdebase.new/ConfigureChecks.cmake --- tdebase/ConfigureChecks.cmake 2012-06-10 11:52:38.000000000 -0500 +++ tdebase.new/ConfigureChecks.cmake 2012-08-11 21:59:00.000000000 -0500 @@ -268,7 +268,7 @@ tde_message_fatal( "dbus-tqt-1 is required, but was not found on your system" ) endif( ) endif( ) - if( WITH_HAL ) +# if( WITH_HAL ) # check for dbus-tqt # dbus-tqt need Qt flags pkg_check_modules( DBUS_TQT REQUIRED dbus-tqt ) @@ -284,6 +284,6 @@ if( NOT HAVE_DBUS_QT3_07 ) tde_message_fatal( "dbus-tqt is required, but was not found on your system" ) endif( ) - endif( ) +# endif( ) endif( ) ================================================= I considered changing if( WITH_HAL ) to if( WITH_HAL OR WITH_TDEHWLIB ), but I don't know whether WITH_TDEHWLIB is dependent upon dbus-tqt. I don't know whether dbus-tqt is required for all builds. I really don't know what is the best all-around long-term solution for all distros. Darrell