> I was browsing through KControl and selected the Wireless Network module. > I later saw the following messages in the xsession-errors log: > > QComboBox::setCurrentItem: (protocolCombo) Index 5 out of range > QComboBox::setCurrentItem: (aclCompatibilityCombo) Index 3 out of range > QComboBox::setCurrentItem: (maxProtocolCombo) Index 5 out of range > QComboBox::setCurrentItem: (serverSigningCombo) Index 3 out of range > lo no wireless extensions. > eth0 no wireless extensions. > > I don't have wireless configured in any manner. Just a wired connection. > > When I selected that module, I received a warning message box four times: > > [Sorry - Control Center] > Unable to detect wireless interface. > (OK button) > > Four warnings match the number of tabs in the module. > > I think that after the user responds to the first message box the > remaining three warnings should be quashed. > > Unchecking the Autodetect check box does not disable the warning messages. > > I don't believe the message warnings add usability value. Possibly a > better method would be to provide a message (in each tab of the module) > that no connection was detected. > > Further, there should be no warning messages if nothing is yet configured. > > Second, the QComboBox messages should not appear in the xsession-error > messages. The content of those messages indicate some kind of code error, > which translates to noise and clutter in the log. Some kind of error trap > is needed to quash the messages. > > Third, the messages about lo and etho should be prefixed with something > like [kcontrol] so users know the source of the messages. Logs are meant > to help users, so let's help them. :) > > I hope this helps! > > Darrell > > Should be fixed in SVN revision 1177996. Tim > >